Violectric HPA V202 Headphone Amp

På lager
7.990  DKK
Leveringstid:5-7 dage

Violectric V202 er en ren hovedtelefonforstærker og en videreudvikling af den mangedobbelte testvinder HPA V200

  • Gratis fragt over 750 DKK
  • Lagervarer sendes indenfor 24 timer
  • Afhentning i butik

Violectric V202 er en ren hovedtelefonforstærker og en videreudvikling af den mangedobbelte testvinder HPA V200


Violectric HPA V202

The Violectric V202 is a pure headphone amplifier and a further development of the multiple test winner HPA V200. It offers the incomparable natural and pleasant sound that made its predecessors famous. With its special technology, the HPA V202 not only offers one of the most powerful headphone amplifiers on the market. Features: The rear line inputs can be selected via a switch on the front. The activated and buffered signal reaches the output stages after the RK 27 volume control, which are a further development of the famous V200 circuits. 

Connect your headphones to the HPA V202 and enjoy a compact and fantastic sounding headphone amplifier with the vaunted natural, smooth yet precise Violectric sound. 

LOW NOISE due to a very small internal amplification. As a result, the amplifier's inherent noise is inaudible. 

HIGH OUTPUT VOLTAGE due to 50 volts internal operating voltage. Therefore best suited for high impedance headphones. 

HIGH OUTPUT POWER due to powerful amplifiers that can deliver far more power than even the most demanding headphones can use. Therefore ideally suited for headphones with low impedances and also magnetostats! 

HIGH DAMPING FACTOR due to lowest output impedance. Therefore ideally suited to drive even the most difficult headphones without interference, with a guarantee of uncompromised frequency response.

Analogue input parameter

Inputs (stereo)    
1 x XLR balanced, 1 x RCA, unbalanced

Max. input voltage    
+ 21 dBu,

Input impedance    
10 kohm

Headphone amp parameter

Nominal input sensitivity
+6 dBu

Feedback gain
+8 dB

PRE-GAIN     
-18 / -12 / -6 / 0 / +6 / +12 / +18 dBr

Frequency range
5 Hz ... 250 kHz (- 0,5 dB)

Output impedance
0,25 Ohm

Damping factor (Load 50 R)
200

Dynamic range
> 128 dB (A-wtd)

Noise
< -100 dBu (A-wtd)

THD+N (1kHz/2x10V/100R=1W)     
< -100 dB / < 0,001 %

THD+N (1kHz/2x4V/32R=0,5W)
< -103 dB / < 0.0007 %

Crosstalk
-100 dB (1 kHz) / -95 dB (15 kHz)

Headphone outputs
1 x Pentaconn, unbal. / 1 x 1/4“ (6.3 mm) TRS jack

General

Supply voltage
230 V AC / 115 V AC max. 10 VA

Front, Back
5 mm / 2,5 mm Aluminum, black anodized

Case
3 mm / 4 mm Aluminum, black anodized

Case dimensions
170 x 54 x 228 mm (W x H x D)

Overall dimensions
170 x 65 x 252 mm (W x H x D)